Siemens SINUMERIK 828D - Page 635

Multi-channel machining
10.2 Multi-channel support
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
635
Parameter
Description
Unit
ZRA Retraction plane Z front (abs) or
retraction plane Z referred to ZA (inc)
mm
ZRI Retraction plane Z rear – (only for retraction "all") mm
Tailstock Yes
• Tailstock is displayed for simulation / simultaneous recording
• When approaching/retracting, the retraction logic is taken into account
No
XRR
Retraction plane – (only "Yes" for tailstock)
mm
Tool change point Tool change point
• WCS (Workpiece Coordinate System)
• MCS (Machine Coordinate System)
• Empty
XT
Tool change point X
mm
ZT
Tool change point Z
mm
SC Safety clearance (inc)
Acts in relation to the reference point. The direction in which the safety clearance is
active is automatically determined by the cycle.
mm
S1
Maximum speed, main spindle
rev/min
Machining
direction
Milling direction:
• Climbing
• Conventional
• Empty
Procedure
1.
The ShopTurn program has been created.
2.
Position the cursor at the location in the program where settings
must be changed.
3.
Pre
ss the "Various" and "Settings" softkeys.
The "Settings" input window opens.