Siemens SINUMERIK 828D - Page 693

Tool management
12.5 Tool list
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
693
Delete tool on code carrier
1.
The tool list is opened.
2.
Position the cursor on the tool on code carrier that you want to delete.
3.
Press the "Delete tool" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code
carrier. The tool is then deleted from the NC memory.
The deletion of the tool can be set differently, i.e. the "On code carrier" softkey is not
available.
References
A description of the configuration options can be found in the following reference:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual