Siemens SINUMERIK 828D - Page 716

Tool management
12.12 Specific search in the tool management lists
Turning
716 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Procedure
1.
Select
the "Parameter" operating area.
...
2.
Press the "Tool list", "Tool wear" or "Magazine" softkey.
3.
Press
the ">>" and "Search" softkeys.
4.
Press the "Tool" softkey if you wish to search for a
specific tool.
- OR -
Press the "Magazine location" softkey if you wish to search for
a specif-
ic magazine location or a specific magazine.
- OR -
Press the "Empty locatio
n" softkey if you wish to search for a specific
empty location.
5.
Press the "OK" softkey.
The search is started.
6.
Press the "Search" softkey again if the tool that was found is
not the
tool that was being searched for.
The search term is kept and with "OK" you start the search for the next
tool that corresponds to the entry.
7.
Press the "Cancel" softkey to cancel the search.