Siemens SINUMERIK 828D - Page 800

Alarm, error and system messages
14.8 Logbook
Turning
800 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Note
Deleting logbook entries
Up to the end of the 2nd commissioning, you have the option to delete the logbook entries
up to the time of the first commissioning using the "Clean up" softkey.
Searching for a logbook entry
You have the option for searching for specific entries using the search function.
1.
The "Machine logbook" window is opened.
2.
Press the "Search..." softkey and enter the desired term in the search
form. You can make a search according to date/time, co
mpany
name/department or according to fault diagnostics/measure
.
The cursor is positioned on the first entry that corresponds to the search
term.
3.
Pres
s the "Continue search" softkey if the entry found is not the one that
you are looking for.
Additional search option
Press the "Go to Beginning" softkey to start the search at the latest e
n-
try.
Press the "Go to End" softkey to start the search at the oldest entry.