Siemens SINUMERIK 828D - Page 81

Setting up the machine
3.5 Measuring the tool
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
81
References
For further information about lathes with B axis, please refer to the following reference:
Commissioning Manual SINUMERIK Operate / SINUMERIK 840D sl
Preconditions
● If you wish to measure your tools with a tool probe, the machine manufacturer must
parameterize special measuring functions for that purpose.
● Enter the cutting edge position and the radius or diameter of the tool in the tool list before
performing the actual measurement. If the tool is measured using a tool carrier that can
be orientated, then the cutting edge position must be entered into the tool list
corresponding to the initial tool carrier position.
● Calibrate the probe first.
Machine manufacturer
Ple
ase refer to the machine manufacturer's specifications.
Procedure
1.
Insert the tool that you want to measure.
If the tool is to be measured using a tool carrier that can be orientated,
then at this position the tool should be aligned in the same way th
at it
will be subsequently measured.
2.
Select "JOG" mode in the "Machine" operating area.
3.
Press the "Meas. tool" and "Automatic" softkeys.
4.
Press the "X" or "Z" softkey, depending on which tool length you want to
measure.
5.
Manually position the tool in the vicinity of the tool probe in such a way
that any collisions can be avoided when the tool probe is being tra
v-
ersed in the corresponding direction.