Easy Message (828D only)
21.4 Setting-up events
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
873
● Maintenance intervals
An SMS is sent if the service planner registers pending maintenance work.
● Additional alarm numbers:
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
● The user profile window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle
messages for workpieces", "Sinumerik messages/alarms (errors when executing)",
"Machine faults" or "Maintenance intervals".
Activate the required chec
k box and press the "Details" softkey.
The appropriate window opens (e.g. "Measuring cycle messages for
workpieces") and shows a list of the defined alarm numbers.
Select the corresponding entry and press the "Delete" softkey to r
e-
move the alarm number from the list.
Then press the "New" softkey if you wish to create a new entry.
The "Create new entry" window opens.
Enter the data and press the "OK" softkey to add the entry to the list.
Press the "Save" softkey to save the settings for the result.
Press the "Standard" softkey to return to the standard settings for the
events.
To Next Page
Loading...
Need help?
General
