Siemens SINUMERIK 828D User Manual

Service Planner (828D only)
23.1 Performing and monitoring maintenance tasks
Turning
882 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Procedure
1.
Select the "Diagnostics" operating area.
2.
Press the menu forward key and then the "Service planner" softkey.
The window with the list of all the maintenance tasks that have been set
up appears.
3.
Perform the maintenance task when the maintenance interval has nea
r-
ly expired or when prompted to do so by alarms or a warning.
4.
After you have performed a pending maintenance task
and the task is
signaled as "Completed", position the cursor at the appropriate task and
press the "Servicing performed" softkey.
A message is displayed confirming the acknowledgment, and the
maintenance interval is restarted.
Note
You can perform the
maintenance tasks before the interval expires. The maintenance
interval is restarted.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash