When the next transition selection button [KEY
PRIOR] is on, the selected key appears on top on the
preview monitor. The priority of keys other than the
selected one does not change.
To change the priority of more than one key, repeat the
previous operation as required.
Chapter
3
Signal
Selection
and
Transitions
•
To select [Key5] to [Key8], or [DSK5] to [DSK8]
requires an assignment (see page 397).
•
The key priority establishes a separate priority order
within each of the groups of keys 1 to 4 and keys 5
to 8. You can make any setting within the groups of
keys 1 to 4 or keys 5 to 8, but not for combinations
of keys from different groups. For example, it is not
possible to set a priority sequence of keys 1, 5, and 2.
Setting the Key Priority by a Menu
Operation
When using keys 1 to 8, set the priority separately for the
two groups (see page 101).
Changing the priority of the currently
inserted keys
Notes
It is not possible to select the same key for two or more
priority numbers.
The keys appear in the set order on the program
monitor.
Changing the key priority for after the
transition
1
In the M/E or PGM/PST menu, select first VF7 ‘Misc,’
then HF4 ‘Next Key Priority.’
The Next Key Priority menu appears.
2
For each of <Priority1>, <Priority2>, <Priority3>, and
<Priority4>, select a key, to determine the key priority
sequence.
For details of the key priority sequence, see the figure
shown for step 2 in the previous item (see page 100).
The keys appear in the set order on the preview
monitor.
3
Execute the transition.
The keys are rearranged in the set order on the program
monitor.
1
In the M/E or PGM/PST menu, select first VF7 ‘Misc,’
then HF3 ‘Key Priority.’
The Key Priority menu appears.
2
For each of <Priority1>, <Priority2>, <Priority3>, and
<Priority4>, select a key, to determine the key priority
sequence.
The keys are inserted in the key priority sequence with
priority 1 at the front.
Priority 2
Priority 1
Priority 4
Priority 3
Display of the Key Output Status and
Key Priority
You can check whether keys are currently output, and the
key priority setting, using the key status display in the
transition control block of the M/E or PGM/PST bank.
The display is above the next transition selection buttons
[KEY1] to [KEY4] ([DSK1] to [DSK4] buttons in the
PGM/PST bank).
Notes
You can change the assignment of the next transition
selection buttons [KEY1] to [KEY4]. If this is changed,
the output status and priority is shown for the assigned key.
Display of the key output status
When a key is included in the output from the M/E or
PGM/PST bank, the corresponding ON indicator lights.
Key priority display
The key priority is indicated by numerals 1 to 4 lighting.
To Next Page
Loading...
