Sony MVS-8000X SystemMVS-7000X System - Chapter 9 Color Corrector; Preparations

USO RESTRITO
240
Preparations
Signal
format
When the color corrector
output is selected
When the
color corrector
output is not
selected
3M/E system
4M/E to 6M/E
systems
4M/E to 6M/E
systems
Other
than
720P
–
Reentry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed over
a cascade of
two or more M/
E blocks
(Restriction 2).
–
720P
Reentry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed over
a cascade of
two or more M/
E blocks
(Restriction 2).
Reentry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed
(Restriction 1).
Reentry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed over
a cascade of
three or more
M/E blocks
(Restriction 2).
Chapter
9
Color
Corrector
Color Corrector
Chapter 9
Preparations
The color corrector enables video signal color correction
(black balance/white balance adjustment, gamma
correction, knee correction, etc.).
Restrictions on color corrector and M/E
combination
Notes
To use the color corrector, the BZS-8420X (for MVS-
8000X) or the BZS-7420X (for MVS-7000X) Color
Corrector Software is required. To use the software, you
are required to input an install key.
For the method of inputting an install key, see
“Installation and Device Setup (Install/Unit Config
Menu)” in Chapter 18 (Volume 2).
Example of restriction 2: When M/E-1 is selected on the
M/E-2 background A bus (or background B bus, key
bus, or utility 1 or 2 bus), then M/E-2 cannot be
selected on the M/E-3 key bus or the utility 1 bus.
Assigning the color corrector input buses
to AUX delegation buttons
There are two inputs for capturing material to the color
corrector: the CCR1 bus and the CCR2 bus.
For details of the input assignment operation, see
“Auxiliary Bus Control Block Settings (Aux Assign
Menu)” in Chapter 19 (Volume 2).