Sony MVS-8000X SystemMVS-7000X System - Color Corrector Functions; Input Video Processing Operations; Primary Color Correction Operations

USO RESTRITO
242
Color Corrector Functions
Chapter
9
Color
Corrector
Swapping color corrector data
Refer to the procedure described in the previous item
“Copying color corrector data.” In step 3, press [Swap]
instead of [Copy].
To undo copy or swap
In the Copy/Swap menu, press [Undo].
The state before carrying out the copy or swap is restored.
Color Corrector
Functions
This section describes the color corrector functions.
For each of the following operations, it is possible to copy
or swap data between two color correctors (CCR1 and
CCR2).
Input Video Processing Operations
Carry out the following corrections to a YUV signal before
conversion to an RGB signal.
• Overall gain adjustment of the video signal
• Gain adjustment of the Y signal
• Gain adjustment of the C signal
• Hue delay
• Black level adjustment
To apply input video processing effects, use the following
procedure.
1 In the CCR menu, press VF1 ‘CCR1’ and HF1 ‘Input
Process.’
The Input Process menu appears.
2 In the <Input Process> group, press [Input Process],
turning it on.
3 Adjust the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Video Gain
Video signal
gain
–200.00 to
+200.00
2
Y Gain
Y signal gain
–200.00 to
+200.00
3
C Gain
Chrominance
signal gain
–200.00 to
+200.00
4
Hue Delay
Hue delay
–180.00 to
+180.00
5
Black
Level
Black level
–116.90 to
+116.90
To return the parameters to their default settings
Press [Unity] in the <Input Process> group.
Primary Color Correction
Operations
Carry out the following corrections to each of the R, G, and
B signals.