Creating and Saving a Master Timeline 465
Chapter
13
Keyframe
Effects
Notes
•
It is not possible to undo a master timeline save.
•
Saving the master timeline does not carry out a save of
effects. Save the effects for each region first, then carry
out the master timeline save.
Changing a master timeline
You can change information already saved in a master
timeline.
As an example, to change the M/E-1 register from Effect 5
to Effect 10, use the following procedure.
This saves M/E-1 register 10 and P/P register 5 in
master timeline register 1.
Checking the regions saved on a master
timeline
For example in the course of changing a master timeline,
you can check which regions are saved in the register.
With the [MASTR] button in the numeric keypad control
block lit, hold down the [STORE] button. While it is held
down, the buttons for the saved regions light. When the
button is released, the state before it was held down is
restored.
Information in master timeline register 1 before change
m
Information in master timeline register 1 after change
1
Recall the master timeline register you want to change
(see page 444).
This simultaneously recalls M/E-1 register 5 and P/P
register 5, and the [M/E 1] and [P/P] region selection
buttons light.
2
Press the region selection button [MASTR], turning it
off.
3
Turn on only the button for the region you want to
change (here, [M/E 1]), and recall the desired register
(here, Effect 10).
This recalls M/E-1 register 10, while on P/P register 5
remains selected.
4
Press the buttons for the regions you want to save on
the master timeline (here, [M/E 1] and [P/P]), turning
them on.
5
Press the region selection button [MASTR], turning it
on.
The display shows the register number last used for
master timeline operation.
6
Press the [STORE] button, turning it on.
7
With the numeric keypad buttons, enter the number of
the register (here “1”) in which you want to save the
master timeline, and press the [ENTER] button.
Creating and Saving a Master
Timeline Using the Buttons in the
Multifunction Flexi Pad Control
Block
Creating and saving a master timeline
1
Press the [EFF] button, turning it on.
This assigns the memory recall section to keyframe
effect operations.
2
Recall the register number of the effect you want to
save on the master timeline for each region (see page
444).
3
Of the region selection buttons, press those buttons for
the regions you want to save on the master timeline,
turning them on.
4
Press the region selection button [MSTR], turning it
on.
The display shows the number of the register last used
for master timeline register operation.
5
Press the [EDIT ENBL] button.
This assigns the memory recall section to keyframe
effect editing operations.
6
Press the [STOR] button, turning it on.
7
With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline.
To find an empty register, instead of entering a
number, press the [.] (period) button.
The display shows the register number. If the number
is followed by a letter “E,” the register is empty.
To Next Page
Loading...
