Shotbox Register Creation
Chapter
15
Utility/Shotbox
[EFF] button lights green to indicate that a setting
operation is in progress for the purpose of saving
snapshot data or effect data in a shotbox register.
5
Press the region button for the snapshot you want to
save, turning it on.
6
Enter the desired shotbox register number with the
numeric keypad buttons.
To find an empty register, instead of entering a
number, press the [.] (period) button.
The display shows the relevant register numbers.
When a register number is postfixed with an “E,” the
register is empty.
7
Press [ENTER].
This saves the region you turned on in step 5, and the
register number you recalled for that region as a
snapshot setting in a shotbox register, and the
[STORE] button goes off. At the same time, the
[RCALL] button lights.
8
In the numeric keypad control block, press the [EFF]
button, turning it on.
9
Specify the register number of the keyframe effect you
want to save in a shotbox register, and then recall it for
each region.
For details of the procedure for recalling a register,
see “Recalling a Register” (page 444).
10Referring to steps 3 to 5, carry out the setting
operation for effect register saving. In step 4, however,
press the [EFF] button, lighting it green.
11Enter the shotbox register number specified in step 6
using the numeric keypad buttons.
12Press the [ENTER] button.
This saves the effect setting in a shotbox register, and
the [STORE] button goes off. At the same time, the
[RCALL] button lights.
To change the contents of a shotbox register
After recalling the shotbox register you want to change,
referring to the previous item “Creating a shotbox
register,” change the contents of the shotbox register, and
save.
To check the region saved in a shotbox register
During operations to change the contents of a shotbox
register, to check which region is saved in the register, use
the following procedure.
1
With the [SHOTBOX] button lit, press the [STORE]
button, turning it on.
2
Press the required button, as follows, turning it on.
To check the snapshot region: [SNAPSHOT] button
To check the effect region: [EFF] button
3
Hold down the [STORE] button.
While this button is held down, the button for the
saved region lights.
Releasing the button returns you to the state before
holding down the [STORE] button.
Notes
While the [STORE] button is lit, the mode selection
buttons ([TRANS RATE] button and so on) in the numeric
keypad control block do not operate. To change the mode,
press the [RCALL] button or [SHOTBOX] button so that
the [STORE] button goes off.
Creating a Shotbox Register in the
Multifunction Flexi Pad Control
Block
1
In the Multifunction Flexi Pad control block, press the
[SNAPSHOT] button, turning it on.
This changes the Multifunction Flexi Pad control
block to snapshot operation mode.
2
Specify the register number of the snapshot you want
to save in a shotbox register, and then recall it for each
region.
For details of the procedure for recalling a snapshot,
see “Recalling a snapshot in the Multifunction Flexi
Pad control block” (page 480).
3
Press the [SHOTBOX] button, turning it on.
This changes the Multifunction Flexi Pad control
block to shotbox operations.
4
Press the [EDIT ENBL] button.
This changes the Multifunction Flexi Pad control
block to shotbox editing mode.
5
Press the [STOR] button, turning it on.
The [SNAPSHOT] button lights green.
If not lighted, press the [SNAPSHOT] button to turn it
on.
To Next Page
Loading...
