Independent Key Transitions 115
Chapter
3
Signal
Selection
and
Transitions
Example 2: When the common transition [AUTO TRANS] button
is pressed later
Basic Independent Key Transition
Operations
Key delegation buttons
Key source name display/key
snapshot buttons
Independent key
transition (mix)
Common transition
(wipe)
Independent key transition execution section
Independent key transition type
selection buttons
The transition
completes with
the key deleted.
Time offset execution with the key not inserted
Independent key transition control block (standard type)
To set independent transitions for the keyers on the M/E or
PGM/PST bank, use the independent key transition control
block.
1 Select one or more of the delegation buttons [KEY1]
to [KEY4] ([DSK1] to [DSK4] in the PGM/PST
bank), turning them on.
You can press more than one button at the same time.
Notes
The buttons for [Key5] to [Key8] and [DSK5] to
[DSK8] require previous assignment in the Setup
menu (see page 397).
2 Select the transition type.
To fade a key in or out: Press the [MIX] button,
turning it on.
To insert or delete a key using a dedicated wipe
pattern: Press the [WIPE] button, turning it on.
To insert or delete a key using a dedicated DME
wipe pattern: Press the [DME] button, turning it
on.
To instantaneously insert or remove the key: press
the [CUT] button, turning it on.
To Next Page
Loading...
