Shotbox Register Editing 495
Chapter
15
Utility/Shotbox
Shotbox Register Editing
You can carry out the following editing on shotbox
registers.
•
Lock: Write-protect the contents of the register.
•
Copy: Copy data from one register to another.
•
Move: Move data from one register to another.
•
Swap: Swap the contents of two registers.
•
Delete: Delete the contents of a register.
•
Name: Attach a name to a register.
The procedures for shotbox register editing are similar to
the procedures described in “Effect Register Editing”
(page 468).
Unlike in effect register editing, however, it is not
necessary to specify a region in shotbox register editing.
To Next Page
Loading...
