Sony MVS-8000X SystemMVS-7000X System - Switching the Input Reference Signal for HD System; Setting Conversion Formats

USO RESTRITO
550
Setting the Signal Format (Format Menu)
Signal format
Input reference signal
Tri Sync
Black burst
1080PsF/29.97
1080P/59.94,
1080i/59.94
59.94
Black Burst
59.94
Sync 59.94
1080PsF/25
1080P/50,
1080i/50
50
Black Burst
50
Sync 50
1080PsF/24
48
–
1080PsF/
23.976
47.952
Black Burst
a)
Sync
a)
720P/59.94
59.94
Black Burst
59.94
Sync 59.94
720P/50
–
Black Burst
50
Sync 50
Chapter
18
System
Setup
(System)
The AUX Signal Format menu appears.
3 In the list, select the relevant data by any of the
following methods.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
longer.
Output 1, Output 2, Output 25, Output 26
Switching the Input Reference
Signal for HD System
Notes
The input reference signal for the MKS-7470X/7471X is
used in common with the switchers.
This changes the input reference signal.
• Tri Sync: tri-level sync for an HD system
• BB (Black Burst): black burst or sync
The following table shows the relation between signal
format and the frequency of a signal that can be used as the
input reference signal.
Knob
Parameter
Adjustment
Setting values
1
Output No
Number to be
selected
1 to 48
For each group, four outputs are selected together.
4 In the <AUX Signal Format> group, select
[59.94Hz(2x)] from the following.
[59.94Hz]: Mode not allowing a 59.94(2x) signal on
the AUX bus.
[59.94Hz(2x)]: Mode allowing a 59.94(2x) signal on
the AUX bus.
5 Press [Execute].
a) Interlock mode
59.94 59.94
A confirmation message appears.
6 To change the mode, select [Yes].
This changes operation to the selected mode.
Even if you press [Execute], the memory is not
reinitialized, and therefore frame memory images and
other data is not lost.
Notes
• When 3D mode is enabled, 59.94(2x) format setting is
invalid.
• It is not possible to select a 59.94(2x) format signal as
output to a small window in the multi viewer.
• If you assign 59.94(2x) to any of the following outputs,
they will not work as a format converter output any
Setting Conversion Formats
Installing the MKS-8450X Format Converter Board in the
MVS-8000X/7000X enables signal video format
conversions.
This operation is valid only when BB is selected in the
<Ref Input Format> group.
In the MVS-7000X, format conversion is assigned to
primary inputs in advance.
For details about the primary input assignment, see
“Selecting the Primary Input to be Used in the Format
Converter” (page 614).
Format converter
Installing the Format Converter Board in the switcher
enables the following signal video format conversions.
• Up-conversion: from SD (4:3) to HD (16:9)