Sony MVS-8000X SystemMVS-7000X System - Setting the Signal Format (Format Menu); Setting the Signal Format; Allowing 59.94(2 X) Format Signals on an AUX Bus

USO RESTRITO
Setting the Signal Format (Format Menu) 549
System
Field frequency
Effective number of
scan lines
HD system
50
1080i
59.94
50
1080P
59.94
23.976
1080PsF
24
25
29.97
50
720P
59.94
SD system
59.94
480i
50
576i
Chapter
18
System
Setup
(System)
Setting the Signal Format
(Format Menu)
To set the format, that is, the frame frequency and number
of scan lines handled by each device, use the System
>Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 ‘System’ and
HF3 ‘Format.’
Notes
After changing any of the following settings, be sure to
press [Execute] (or [FC Format Execute] for changing the
format converter signal format) to save the new values. If
you want to cancel the settings and return to the original
state, press [Clear] without pressing [Execute] or [FC
Format Execute]. When you press [Execute], some data is
lost (such as frame memory images). If you press [FC
Format Execute], memory is not initialized, and this data
is not lost.
Restrictions on signal formats and reentry
Reentry restrictions for an M/E on which a selected signal
format can be used depend on whether or not the color
corrector is used.
For details, see “Preparations” in Chapter 9 (Volume 1).
Setting the Signal Format
Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are
as follows.
Notes
When the MVS-8000X is used with the 1080P signal
format or the MVS-7000X is used with multiple signal
formats, you need to install software options (see page
556).
1 In the System >Format menu, select the device for
operations.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob
Parameter
Adjustment
Setting values
1
Device
Selection of
device for
operations
1 to maximum
value
2 Press [Signal Format].
A pop-up window appears.
3 Press the button for the desired signal format.
Allowing 59.94(2x) Format Signals
on an AUX Bus
When the signal format of this system is 1080i/59.94, it is
possible to handle different (59.94(2x)) format signals on
the AUX bus only.
You can output from a connector to which any of the
following is assigned.
Preset, Edit Preview, AUX 1 to 48
Carry out the setting in the Engineering Setup >System
>Format >AUX Signal Format menu.
1 Press [Signal Format] in the Engineering Setup
>System >Format menu, and then select [1080i/
59.94].
2 Press [AUX Signal Format].