Screen Saver and Other Settings (Maintenance Menu) 607
Chapter
19
Control
Panel
Setup
(Panel)
Screen Saver and Other
Settings (Maintenance
Menu)
To make settings relating to the screen saver, etc., use the
Panel >Maintenance menu.
•
Screen Saver: Make the menu display saver settings.
•
LCD Brightness: Adjust the LCD brightness.
•
LED Brightness: Adjust the LED brightness.
•
Switch Brightness: Adjust the switch brightness.
•
Touch Beep: Select whether or not to sound a beep
when a menu operation is carried out.
•
Touch Panel Calibration: Calibrate the touch panel.
•
Initial Menu Set: Specify the menu to be displayed at
menu startup.
•
Scrl Down = Clockwise/ Scrl Up = Clockwise: Set the
mouse wheel scrolling direction for parameter setting.
•
Mouse Slider Control: Select the mouse button used for
adjusting the bar positions of the knob parameters.
To display the Maintenance menu
In the Engineering Setup menu, select VF2 ‘Panel’ and
HF7 ‘Maintenance.’
The status area shows a list of the items with their settings.
Screen Saver Settings
To enable the menu display saver, use the following
procedure.
1
In the Panel >Maintenance menu, press [Screen
Saver], turning it on.
2
Adjust the following parameter.
Time until screen
saver starts
operation
Adjusting the Brightness
You can adjust the brightness of the following hardware
parts.
LCD: Adjust the brightness of the source name displays
and the LCD buttons in the Flexi Pad control block.
LED: Adjust the brightness of the LED displays in the
numeric keypad control block and so forth.
Switch: Adjust the brightness of the panel switches.
The following description takes the LCD brightness as an
example. Use a similar process for the other adjustments.
1
In the Panel >Maintenance menu, press [LCD
Brightness].
2
Adjust the following parameter.
a)
The larger the value, the brighter the screen.
Setting Whether or not to Sound a
Beep when a Touch Operation is
Carried Out
In the Panel >Maintenance menu, press [Touch Beep].
Each time you press this button, it toggles the beep setting
on and off.
Calibrating the Touch Panel
1
In the Panel >Maintenance menu, press [Touch Panel
Calibration].
The following message appears.
“To Perform Calibration, please touch the center of
each plus sign.”
2
Press [Yes].
3
Press the center of the plus sign displayed on the
screen.
When you press on the plus sign, it disappears and a
diagonally opposite plus sign appears.
4
Press the center of the plus sign.
A confirmation message appears.
•
Select “Yes” to restart the panel reflecting the new
setting.
•
Select “No” to cancel the setting and return to the
Maintenance menu.
Setting the Menu to be Shown When
the Menus Are Started
1
In the Panel >Maintenance menu, press [Initial Menu
Set].
A popup window appears.
2
Enter the page number of the desired menu.
To Next Page
Loading...
