Sony MVS-8000X SystemMVS-7000X System - Metal Settings; DIM and Fade Settings

USO RESTRITO
Applying Special Effects (Effects on the Overall Video Signal) 309
Knob
Parameter
Adjustment
Setting values
3
Y Gain
Amount of
gain for clip
adjusted
input signal
Y level
–100.00 to +100.00
4
Y Offset
Offset added
to clip and
gain
adjusted
input Y
signal
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
1
Mix Ratio
Mix amount
for Metal
video and
input video
0.00 to 100.00
2
Y Clip
Clip level of
input signal
Y level
0.00 to 100.00
Chapter
11
DME
Operations
To set the color of the sections other than the
outlines for Draw
Press [Matte], turning it on, and adjust the following
parameters to set the color of the sections other than
the outlines.
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
To select the signal to mix with the relief pattern for
Relief
In the <Chroma Type> group, select the signal to mix
with the relief pattern.
Matte: Select a single color. The following
parameters can be adjusted.
Knob
Parameter
Adjustment
Setting values
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Video: Select the input video signal.
6 To invert white and black in the extracted video, or to
invert the outlines and the sections other than the
outlines, press [Nega], turning it on.
Masking the Sketch effect with a selected
pattern
Press [Mask] to display the Mask menu and set the type of
pattern and modifiers (see page 310).
Metal Settings
Applying the Metal effect
1 In the DME menu, select VF7 ‘Enhanced Video
Modify’ and HF2 ‘Metal.’
The Metal menu appears.
2 Press [Metal], turning it on.
3 Set the parameters.
4 In the <Metal Mode> group, select the type of metallic
gloss.
Gold: Give a gold gloss to the input video.
Silver: Give a silver gloss to the input video.
Rainbow: Give a rainbow color gloss to the input
video.
Variable: Give a metallic gloss to the input video in
any color by adjusting the following parameters.
Knob
Parameter
Adjustment
Setting values
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Masking the Metal effect with a selected
pattern
Press [Mask] to display the Mask menu and set the type of
pattern and modifiers (see page 310).
Dim and Fade Settings
Notes
The Dim and Fade functions are not supported on the
MVE-8000A.
Applying the Dim effect
1 In the DME menu, select VF7 ‘Enhanced Video
Modify’ and HF3 ‘Dim & Fade.’
The Dim & Fade menu appears.
2 Press [Dim], turning it on.
3 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Start
Point where
dimming
starts (dim
start point)
–100.00 to +100.00