Names and Functions of Parts of the Control Panel
Chapter
2
Menus
and
Control
Panel
For details, see the section “Assigning a Function to the
Independent Key Transition Control Block (Simple Type)”
in Chapter 19 (Volume 2).
Downstream Key Control Block
1
Key delegation buttons
5
Key source name display/key snapshot buttons
4
Key snapshot setting
buttons
2
Independent key
transition type selection
buttons
3
Independent key
transition execution
section
a
Key delegation buttons
Press one of the [DSK1] to [DSK4] buttons to delegate this
control block to the corresponding keyer.
Using the Setup menu, it is possible to assign these to
DSK5 to DSK8 or M/E keys 1 to 8.
While these buttons are held down, you can select a key
source with the cross-point buttons for the key bus.
Pressing one of these buttons twice in rapid succession
changes its state so that you can make cross-point
selections on the corresponding key bus.
b
Independent key transition type selection buttons
Press one of these buttons, turning it on, to select the
downstream key transition type.
Instantaneously insert or delete the key
selected with the key delegation buttons.
When setting is made in the Setup menu to
allow a different transition type for inserting or
deleting a key, it is possible to display and set
the transition after the next transition while
this button is held down.
c
Independent key transition execution section
This section is used to carry out an independent key
transition, and check the progress of the transition.
Transition indicator
Fader lever
Carry out a dissolve with the key selected with
the key delegation buttons.
Carry out a wipe with the key selected with the
key delegation buttons.
This switches the key selected with the key
delegation buttons, using a DME wipe.
To Next Page
Loading...
