Screen Saver and Other Settings (Maintenance Menu)
Chapter
19
Control
Panel
Setup
(Panel)
The next time the menus are started, the menu
specified by this number appears.
Notes
To enable this setting, the initial state of the control panel
when powered on must be set to one of the following.
•
Set to Resume mode
•
Set to Custom mode, with “User” selected in the
<Setup> group.
For details of these settings, see “Selecting the State After
Powering On (Start Up Menu)” (page 553).
Setting the Mouse Wheel Scrolling
Direction for Parameter Setting
In the <Mouse Wheel Direction> group of the Panel
>Maintenance menu, press one of the following buttons.
Scrl Down = Clockwise: Turning the mouse wheel in the
direction to scroll down is the same as turning the
parameter setting knob clockwise.
Scrl Up = Clockwise: Turning the mouse wheel in the
direction to scroll up is the same as turning the
parameter setting knob clockwise.
Selecting the Mouse Button Used for
Adjusting the Knob Parameters
In the Panel >Maintenance menu, press either of the
following buttons in the <Mouse Slider Control> group.
Left Button: Dragging the bar while holding down the left
mouse button adjusts the parameter assigned to the
knob.
Right Button: Dragging the bar while holding down the
right mouse button adjusts the parameter assigned to
the knob.
Notes
When Left Button selected, even pressing one of the knob
parameter buttons in the menu control block does not
display a numeric keypad window.
To Next Page
Loading...
