Sony MVS-8000X SystemMVS-7000X System - Wipe Crop Settings

USO RESTRITO
300
Applying Special Effects (Edge Effects)
1
Press [Flex Shadow], turning it on.
2
In the <Flex Shadow> group, select [External].
3
Turn [Axis Loc] on and use knob 2 to set the Axis Loc
V parameter so that the center of the flex shadow
deformation is at the bottom of the picture (for HD
format and 16:9 mode: Axis Loc V = –9.00).
The following steps will be easier if you display the
flex shadow axis graphic by pressing [Flex Shadow
Axis] in the Graphic menu.
4
Press [V] in the <Invert> group, turning it on, to invert
the flex shadow vertically.
5
Turn [Size] on and use knob 2 to set the Size V
parameter so that the shadow extends vertically (for
HD format and 16:9 mode: Size V = 1.50).
6
Press [Skew], turning it on, and use knob 1 to set the
Skew H parameter so that the parallel lines appear to
emerge from the depth at the right (for HD format and
16:9 mode: Skew H = –50.00).
Chapter
11
DME
Operations
Wipe Crop Settings
Notes
• The wipe crop function is not supported on the MVE-
8000A.
• When wipe crop is on, any mask that was on is turned
off.
• When brick is on, wipe crop cannot be turned on. To turn
wipe crop on, it is first necessary to turn brick off.
• In the <Shaped Video> group of the Video/Key menu,
when [Output] is off, unless you set [Bkgd] in the HF1
‘Bkgd’ menu to on, the wipe crop effect will not
function.
Applying the wipe crop effect
To select the pattern
1 In the DME menu, select VF1 ‘Edge’ and HF6 ‘Wipe
Crop.’
The Wipe Crop menu appears.
2 Press [Wipe Crop], turning it on.
3 Press [Pattern Select].
The Pattern Select menu appears.
4 From the displayed patterns (standard wipe patterns 1
to 24 and 304), press any pattern to select it.
In this state, you can use the knobs to adjust the size of
the pattern. For details of parameters, see the next
item.
To set the pattern size and position
1 In the Wipe Crop menu, press [Position/Size].
2 Set the following parameters.
The setting range for the parameters depends on the
signal format (SD/HD) and aspect ratio (4:3/16:9)
selected in the system, as follows.
For SD format
Knob
Parameter
Adjustment
Setting values
1
H
Horizontal
position
–8.00 to +8.00
2
V
Vertical
position
–6.00 to +6.00
a)
–4.50 to +4.50
b)
3
Size
Pattern size
0.00 to 100.00
5
Pattern
Pattern
number
1 to 24, 304
a) For 4:3 mode
b) For 16:9 mode
Notes
When pattern number 304 is selected, the effect of
settings in the <Edge> group varies with the Size
setting.
For HD format
Knob
Parameter
Adjustment
Setting values
1
H
Horizontal
position
–24.00 to +24.00
a)
–32.00 to +32.00
b)
2
V
Vertical
position
–18.00 to +18.00
3
Size
Pattern size
0.00 to 100.00
5
Pattern
Pattern
number
1 to 24, 304
a) For 4:3 mode
b) For 16:9 mode