Names and Functions of Parts of the Control Panel 37
Chapter
2
Menus
and
Control
Panel
e
DSPLY [display] button
Press to light this button, in order that the source name /
bus name displays show the signal names or bus names
corresponding to the current bus delegation.
f
DEST button
When both the [DSPLY] button and this button are on, the
key bus names or AUX bus names are displayed.
g
KEY button
When you press a cross-point button while holding down
this button, the key signal is selected.
Transition Control Block (Standard Type)
In the transition control block, you can modify the output
of the M/E bank or PGM/PST bank, and perform
transitions. Both common transition and independent key
transition operations are possible.
9
PRIOR SET button
1
Next transition selection buttons
8
Key status display
2
Transition type selection buttons
q;
Key delegation buttons
qd Key source name display/key
snapshot buttons
qf
Key
snapshot
setting
buttons
qs Independent key transition execution section
qa Independent key transition type selection buttons
7
KF button
6
Pattern limit buttons
5
TRANS PVW button
3
Transition execution section
4
Wipe direction selection buttons
a
Next transition selection buttons
Press these buttons, turning them on, to determine what the
next transition will apply to.
To Next Page
Loading...
