Sony MVS-8000X SystemMVS-7000X System - Fade to Black Control Block; Auxiliary Bus Control Block (for AUX Buses)

USO RESTRITO
56
Names and Functions of Parts of the Control Panel
Name
Description
PST
(preset)
When this button is pressed, the signal
selected on the background B row of the
PGM/PST bank is selected on the edit
preview bus.
M/E 1 to
M/E 5, P/P
(M/E 1 to
M/E 5, P/P
preview)
The preview signal (M/E-1 PVW, M/E-2 PVW,
M/E-3 PVW, M/E-4 PVW, M/E-5 PVW, P/P
PVW) of the
M/E or PGM/PST bank corresponding to the
pressed button is selected on the edit preview
bus.
For details of [M/E 4] or [M/E 5] button
assignment, see “Assigning a Button for M/E-
4 or M/E-5 Selection in the Setup Menu”
(page 396) in Appendix.
M/E 1K to
M/E 5K, P/P
K (M/E 1 to
M/E 5, P/P
key
preview)
The key preview signal (M/E-1 K-PVW, M/E-2
K-PVW, M/E-3 K-PVW, M/E-4 K-PVW, M/E-5
K-PVW, P/P K-PVW) of the M/E or PGM/PST
bank corresponding to the pressed button is
selected on the edit preview bus.
For details of [M/E 4] or [M/E 5] button
assignment, see “Assigning a Button for M/E-
4 or M/E-5 Selection in the Setup Menu”
(page 396) in Appendix.
DME V
(DME
monitor
video)
When this button is pressed, the DME monitor
output video signal (DME MON V) is selected
on the edit preview bus.
DME K
(DME
monitor key)
When this button is pressed, the DME monitor
output key signal (DME MON K) is selected
on the edit preview bus.
Chapter
2
Menus
and
Control
Panel
Fade to Black Control Block
3 AUTO button
1 FTB button
2 Preview selection buttons
a FTB (fade to black) button
Press this button to fade to black the program output of the
PGM/PST bank, at the set transition rate. You can set the
fade to black transition rate in the menu.
b Preview selection buttons
Each of these buttons can be assigned to any preview
output in setup.
Each button can be assigned to any preview output in
setup.
For details, see “Assigning Preview Output to Preview
Selection Buttons” in Chapter 19 (Volume 2).
c AUTO button
When this button is pressed, the M/E or PGM/PST bank
preview signal selected on the edit preview bus is
automatically switched to the program signal depending
on the on-air status.
Auxiliary Bus Control Block (for AUX Buses)
There are also models without the selected source name
displays and source name displays shown in the following
figure.
All operations except those of the [DEST] button and
[SHIFT] button are the same as for a model with selected
source name displays and source name displays.