Chapter
10
Special
Functions
Image showing view
from right eye
Image showing view
from left eye
X-axis
Combined by brain into
stereoscopic image
For some signals, such as titles, the same signal is used for
both left and right.
Specify whether to use a combination of left and
right signals in the same slot or different slots
1
Display the Engineering Setup >System > Install/Unit
Config > Unit Config menu.
2
In <3D Connector Pair> group, select either of the
following.
1-2 Mode: Specify a pair of left and right signals in the
same slot.
1-21Mode: Specify a pair of left and right signals in
different slots.
3
Press [Execute].
Left eye
Z-axis
Right eye
Combinations of left and right signals
(Input terminals)
The following combinations of left and right signals are
available depending on whether to use the signals in the
same slot or different slots.
If [1-2 Mode] is selected on MVS-8000X
Parallax (spacing between eyes)
Increasing the parallax value increases the
apparent stereoscopic effect.
Preparations
Switching the system to 3D mode
Notes
It is only possible to switch to 3D mode when the system
signal format is set to one of the following.
1080i/50, 1080i/59.94, 720P/50, 720P/59.94
1
Display the Engineering Setup >System >Format
menu.
2
Press [3D Mode], turning it on.
A popup window appears, with a message.
3
Check the message, and select [Yes].
Input primary numbers for left and right
signals
For the signals used in 3D mode for the left eye view and
right eye view (referred to simply as left and right signals),
select a combination of primary input numbers from two
types (signals in the same slot and signals in different
slots).