Names and Functions of Parts of the Control Panel 71
Chapter
2
Menus
and
Control
Panel
For details, see “Setting the Key Priority in the Transition
Control Block” (page 98).
h
Independent key transition execution section
KEY1 TRANS (transition) to KEY8 TRANS (DSK1
TRANS to DSK8 TRANS in the PGM/PST block)
buttons: Press the corresponding one of these buttons
to cut key 1 to key 8 in or out automatically at the set
transition rate. When the key corresponding to the
button appears in the final program output, the button
lights red, and otherwise lights amber. During a
transition, the button lights green.
CCP-6224 2M/E Control Panel
In this system, you can use the built-in CCP-6224 2M/E
Control Panel. This panel has two cross-point control
blocks, two transition control blocks (compact type), one
device control block (trackball), and one Multifunction
Flexi Pad control block.
2
Transition control block (compact type)
3
Device control block
(trackball)
4
Multifunction Flexi
Pad control block
1
Cross-point control block
a
Cross-point control block
For details of cross-point control block operation, see
“Cross-Point Control Block” (page 32).
For operations in AUX control mode, see “Auxiliary Bus
Control Block (for AUX Buses)” (page 56) and “Cross-
Point Control Block (CCP-6224/6324) in AUX Operating
Mode” (page 72).
b
Transition control block (compact type)
For details of operations, see “Transition Control Block
(Compact Type)” (page 68).
c
Device control block (trackball)
For details of operations, see “Device Control Block
(Trackball)” (page 45).
d
Multifunction Flexi Pad control block
For details of operations, see “Multifunction Flexi Pad
Control Block” (page 73).
CCP-6324 3M/E Control Panel
In this system, you can use the built-in CCP-6324 3M/E
Control Panel. This panel has three cross-point control
blocks, three transition control blocks (compact type), one
device control block (trackball), and one Multifunction
Flexi Pad control block.
To Next Page
Loading...
