Sony MVS-8000X SystemMVS-7000X System - Wind Settings

USO RESTRITO
Applying Special Effects (Lighting and Recursive Effects) 335
Chapter
11
DME
Operations
• When you do not combine images, the Keyframe Strobe
effect only is applied, regardless of the selection in the
<Combine Process> group.
Select one of the following in the <Combine Process>
group.
Combine –> KF STRB: Add the Keyframe Strobe effect
after the combine.
As parameters, the data for the channel with the lowest
number among the channels being combined is
enabled.
KF STRB –> Combine: Add the Keyframe Strobe effect
before the combine.
Parameters can be set independently for each channel.
Wind Settings
Selecting the signal for the afterimage
portion
In the <Wind Source> group, select the image to fill the
afterimage portion.
Notes
• “Mix Color” or “Ext Video” can only be applied to one
of the background (see page 344), flex shadow (see page 296), trail (see page 331), and wind effects.
If you select “Mix Color” or “Ext Video” in the wind
settings, a selection of “Mix Color” or “Ext Video” in
any of the other effects is disabled, and “Flat Color” is
selected in its place.
• When executing combining four channels of DME
images, “Mix Color” and “Ext Video” cannot be
selected.
Notes
• The wind function is not supported on the MVE-8000A.
• When wind is turned on, any of the following effects that
are on are turned off.
- Trail
- Motion decay
- Keyframe strobe
Applying the wind effect
1 In the DME menu, select VF5 ‘Light/Trail’ and HF5
‘Wind.’
The Wind menu appears.
2 Press [Wind], turning it on.
3 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Decay
Amount of
afterimage
displayed
0.00 to 100.00
a)
2
Shift H
Extension in the
horizontal
direction
–100.00 to
+100.00
3
Shift V
Extension in the
vertical
direction
–100.00 to
+100.00
a) 0.00 represents no afterimage, and 100.00 represents no decay in the
afterimage.
4 To erase the afterimages, press [Wind Eraser], turning
it on.
Freeze Video: Freeze the input image to use as the
afterimage.
Flat Color: Use a single color matte for the afterimage;
you can set the following parameters with the knobs.
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Hue Rotate: Use a single color matte with the hue
changing for each frame as the afterimage; you can set
the following parameters with the knobs.
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Speed
Rate at which
hue changes
–12.00 to +12.00
Mix Color: Insert a mix color signal (see page 302) in the
afterimage portion.
Ext Video: Insert the external video signal input to the Ext
IN connector in the afterimage portion.
Rainbow: Use a freeze image with the hue changing every
frame in the afterimage portion. The difference from
“Hue Rotate” is that many colors appear
simultaneously.
For details of the Rainbow parameters, see the “Hue
Rotate” item above.
Applying modulation to the afterimage
portion (Modulation)
1 In the Wind menu, press [Modulation], turning it on.
2 Set the following parameters.