Applying Special Effects (Lighting and Recursive Effects) 331
Intensity of
diffuse light
area
Offset of
center of
diffuse light
area
a)
–12.00 to +12.00
b)
–16.00 to +16.00
c)
Width of
diffuse light
area
Softness of
diffuse light
area
Degree to
which the
trail is left
Proportion of
the interval
between two
successive
freeze
images for
which the
video is run
Chapter
11
DME
Operations
Mat: An effect like light striking paper, cloth, or
another diffusively reflective surface.
2 Set the following parameters.
–4.00 to +4.00
Trail Settings
Notes
Turning Trail on when Motion Decay, Keyframe Strobe,
or Wind is on turns it off automatically.
Applying the Trail effect
1
In the DME menu, select VF5 ‘Light/Trail’ and HF2
‘Trail.’
The Trail menu appears.
2
Press [Trail], turning it on.
3
Set the parameters.
a)
For SD 4:3 and SD 16:9
b)
For HD 4:3
c)
For HD 16:9
3 When you select Normal or Mat in step 1, press [Bar
Diffuse Color], turning it on, and adjust the following
parameters to set the color of the diffuse light area.
With no selection
made in the <Bar
Light Mode> group
Bar Light
Diffuse Light
Bar Light
With a selection made in
the <Bar Light Mode>
group
Width
Diffuse Light
a)
0.00 is no trail. At 100.00, the trail does not disappear.
4 To erase the trail, press [Trail Eraser], turning it on.
Switching the priority between the current
image and trail superimposed
In the <Priority> group, select the method of
superimposition.
Over: Current image is on top.
Under: Trail is on top.
Selecting the source to create a trail
In the <Trail Source> group, select the source to create a
trail.
Offset = 0
Notes
•
“Rainbow,” “Mix Color,” and “Ext Video” are not
supported on the MVE-8000A.
•
“Mix Color” or “Ext Video” can only be applied to one
of the background (see page 344), flex shadow (see page
296), trail, and wind (see page 335) effects.
If you select “Mix Color” or “Ext Video” in one of these
To Next Page
Loading...
