Names and Functions of Parts of the Control Panel 59
Press the source
selection button.
Press the [SHIFT]
button, then press the
source selection
button.
Hold down the [KEY]
button, and press the
source selection
button.
Hold down the [KEY]
button, and press the
[SHIFT] button,
turning it on (the
[SHIFT] button locks
here, even when in
Hold mode), then
press the source
selection button.
Chapter
2
Menus
and
Control
Panel
If the source names and destination names are set in the
Setup menu to “Sw’er Local” mode, then the description
names appear here.
c
DEST (destination) button
Press this button, turning it on, to display the names of the
destinations assigned to the destination selection buttons in
the selected source name displays.
d
Selected destination display
This shows the name of the destination selected by the
destination selection buttons. If a protected destination is
selected, the indication “PROTECT” appears.
e
Source selection button rows
The destination selected with a destination selection button
is assigned to a source selection button. Press a source
selection button to select a source. The 1st row of buttons
are source selection buttons for the unshifted destinations,
and the 2nd row are shifted source selection buttons. By
holding down the [2ND] button, and selecting a
destination, you can assign a different destination from the
1st row to the 2nd row. In the 1st row, the button to which
a destination is assigned lights amber. If a different
destination is assigned to a button in the 2nd row, the
button lights green.
When the 32nd button is set as a [SHIFT] button (in a 32-
button system), you can select the shifted sources in the 1st
and 2nd rows. Also, by using the [KEY] button, you can
expand the source selection as follows.
See “Using the Auxiliary Bus Control Block for Router
Control Setting Button” in Chapter 19 (Volume 2).
h
2ND button
After selecting a destination with the destination selection
buttons, hold down this button and make another
destination selection to assign a different destination from
the 1st row to the 2nd row.
i
Source name displays
These display the names of signals (sources) that can be
selected with the cross-point buttons. While the [SHIFT]
button is active, the shifted signal names appear. While the
[KEY] button is held down, the expanded signal names
appear.
When a different destination is assigned to the 2nd row, the
2nd row signal names appear only while the [2ND] button
is held down.
j
SHIFT button
While this button is active, the source name displays show
the shifted signal names. Press this button to toggle
between the shifted and unshifted states.
k
AUX mix buttons
Used when the auxiliary control block is operating on
AUX buses.
l
RTR (router) button
Press this button, turning it on, to assign the auxiliary bus
control block to router control.
m
Level selection buttons
To each of the four buttons, plural S-Bus levels are
assigned in the Setup menu. Press a button, turning it on,
to make operations apply to those S-Bus levels.
Menu Control Block
1
Top menu selection buttons
2
Menu display
f
XPT HOLD (cross-point hold) buttons
Not used in router control mode.
g
KEY button
When this button is enabled by a setting in the Setup menu,
4
User preference buttons
a
Top menu selection buttons
3
Knobs
holding it down during a source selection expands the
function of the [SHIFT] button.
These select the menu appearing in the menu display.
To Next Page
Loading...
