Sony MVS-8000X SystemMVS-7000X System - Deleting Parallel Tally Settings; Serial Tally Settings (Serial Tally Menu); Setting or Changing the Serial Tally Settings; Making the Serial Tally Source Address Settings

USO RESTRITO
658
Serial Tally Settings (Serial Tally Menu)
Knob
Parameter
Adjustment
Setting values
1
Address
Destination
address
1 to 1024
2
Level
Destination level
1 to 8
Knob
Parameter
Adjustment
Setting values
3
Type
Tally type
1 to 16
a)
Knob
Parameter
Adjustment
Setting values
1
Slot No
Parallel tally slot
number
2 to 6
2
Port No
Parallel tally port
number
1 to 54
Chapter
23
Setup
Relating
to
Router
Interface
and
Tally
(Router/Tally)
6 When setting the tally type, set the following
parameter.
a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6,
12:G6, 13:R7, 14:G7, 15:R8, and 16:G8 (R is an abbreviation of
“Red Tally,” and G of “Green Tally”).
7 Press [Execute].
This makes the parallel tally settings, in accordance
with the settings in steps 1 to 6.
Deleting Parallel Tally Settings
1 In the Router/Tally >Parallel Tally menu, using any of
the following methods, select the parallel tally whose
settings you want to delete.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
2 Press [Clear].
Serial Tally Settings
(Serial Tally Menu)
To make serial tally settings, display the Router/Tally
>Serial Tally menu.
Make the serial tally settings, including tally type and
source address for each serial tally port.
To display the Serial Tally menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’
and HF7 ‘Serial Tally.’
The serial tally settings appear in the status area.
Setting or Changing the Serial Tally
Settings
1 In the <Serial Tally Port> group of the Router/Tally
>Serial Tally menu, select the port to which the setting
applies.
2 In the <Tally Group> group, select the tally group.
3 In the <Tally Type> group, press the tally types to
select. You can select up to four.
Notes
The selectable tally types depend on the settings in
step 2.
4 In the <Tally Data Size> group, press one of the
following to select the data size.
128 Bit: 128 bits
256 Bit: 256 bits
Making the Serial Tally Source
Address Settings
To set the serial tally source address for each port, use the
following procedure.
1 In the Router/Tally >Serial Tally menu, press [Source
Assign].
The Source Assign menu appears.
In the status area, the tally types and source address set
for the serial tally port appear.
2 In the <Serial Tally Port> group, select the port to
which the setting applies.