Sony MVS-8000X SystemMVS-7000X System - Setting the Fade to Black Transition Rate; AUX MIX Transitions

USO RESTRITO
AUX Mix Transitions 119
Chapter
3
Signal
Selection
and
Transitions
Setting the Fade to Black Transition
Rate
Setting the fade to black transition rate
1 In the PGM/PST menu, select first VF7 ‘Misc,’ then
HF1 ‘Transition.’
The Transition menu appears.
2 Select [FTB].
3 Turn the knob to set the fade to black transition rate.
Knob
Parameter
Adjustment
Setting values
1
Transition
Rate
Transition rate
0 to 999 (frame
count)
Displaying the transition rates in a menu
and changing the settings
You can also display the transition rate, independent key
transition rate, and fade-to-black transition rate for each of
the M/E and PGM/PST banks, and change the settings (see
page 234).
AUX Mix Transitions
In addition to M/E and PGM/PST, you can make
transitions between two AUX buses.
Notes
AUX mix transitions cannot be executed in 3D mode.
Preparations for AUX mix transitions
The following preparations are required.
Preparations
Refer to
Assign the two AUX buses
used for the AUX mix to
consecutive odd-numbered
and even-numbered output
connectors (for example,
Output 1 and Output 2).
“Enabling AUX Mix
Transitions” in Chapter 20
(Volume 2)
Set the AUX mix transition
rate.
page 235
Executing an AUX mix transition
You execute an AUX mix transition using the [AUX MIX]
button on the cross-point control block (Key/AUX bus
delegation mode or the CCP-6224/6324 in AUX operating
mode) or the auxiliary bus control block.
The following describes the use of AUX1 and AUX2
buses on the auxiliary bus control block as an example.
The operation can be performed in the same manner on the
cross-point control block.
AUX delegation buttons
AUX MIX button
Cross-point buttons
Auxiliary bus control block
1 In the auxiliary bus control block, press the AUX
delegation button assigned to the AUX1 bus, turning it
on.