Creating and Saving a Master Timeline
Press the [EFF] button, turning it on.
This assigns the memory recall section to effect
Press the region selection button corresponding to the
region for which you want to save the register, turning
Press the [EDIT ENBL] button.
This assigns the memory recall section to effect
Press the [STOR] button, turning it on.
With the numeric keypad, enter the number of the
register in which you want to save the effect.
To find an empty register, instead of entering a
number, press the [.] (period) button. To search for an
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in that order. Similarly, to
search for an empty register in the 200 range, press [2],
[0], [0], [.] (period), and to search for an empty register
in the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the
number is followed by a letter “e” or “E,” this indicates
e: The selected register is empty for the regions
Chapter
13
Keyframe
Effects
Saving an effect with the Multifunction
Flexi Pad control block
Creating and Saving a
Master Timeline
selected in step 2.
E: The selected register is empty for all selectable
regions.
6 Press the [ENTR] button.
This saves the current effect in the specified register,
and turns off the [EDIT ENBL] button.
Creating and Saving a Master
Timeline Using the Buttons in the
Numeric Keypad Control Block
Creating and saving a master timeline
You can save region information (information on any
regions, including the register numbers associated with the
regions) referred to as a master timeline in a dedicated
register. By recalling that register, you can manipulate the
regions and registers together.
1
Press the [EFF] button, turning it on.
This assigns the numeric keypad control block to
keyframe effect operations.
2
Recall the register number of the effect you want to
save on the master timeline for each region (see page
444).
3
Of the region selection buttons, press those buttons for
the regions you want to save on the master timeline,
turning them on.
4
Press the region selection button [MASTR], turning it
on.
The display shows the number of the register last used
for master timeline register operation.
5
Press the [STORE] button, turning it on.
6
With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline.
To find an empty register, instead of entering a
number, press the [.] (period) button.
The display shows the register number. If the number
is followed by a letter “E,” the register is empty.
7
Press the [ENTER] button.
The regions selected in step 3 and the register numbers
recalled in those regions are saved in the master
timeline register, and the [STORE] button goes off. At
the same time, the [RCALL] button lights.
To Next Page
Loading...
