Frame Memory Clip Operations 215
In the Frame Memory menu, select VF2 ‘Clip’ and
The Play menu appears. The status of the clip shown
in the current target FM selection buttons appears here.
Frame memory
selection area
Pair selection buttons
Frame memory
1
In step 7 above, instead of pressing [Recall], press
[Direct Recall].
2
Press the thumbnail for the file you want to recall.
Target selection buttons
folder selection area
To display the subsidiary file in front
With the direct recall mode on, press [Sub Display],
turning it on.
To search the clip file by file name
Press [Find] (see page 210).
Clip Playback
You can play a recalled clip by a menu operation or by
using the device control block.
Clip file selection area
Direct Recall button
Find button
Notes
With a pair file recalled, it is possible to set [Pair] to Off
and carry out a single file operation, but if you then set
[Pair] to On again, the output of frame memory may be
black. In such cases it is necessary to recall the pair file
once more.
2
In the frame memory selection area, select an assigned
target FM (see page 207).
3
If [Direct Recall] is on, press the button, turning it off.
4
In the frame memory folder selection area, select the
desired folder.
By pressing [More] to switch the displays, you can
select from a maximum of 12 folders.
5
Using the arrow keys or turning the knob, scroll the
file thumbnail display.
Thumbnail
display
scrolling
6
Press the thumbnail of the clip you want to recall.
7
Press [Recall].
This recalls the clip file, which is assigned to the FM
you selected in step 2.
In pair mode, if a clip is selected, the main file is output
to FM1, and the sub file to FM2. In single mode, when
Playing a clip using the menu
Current position
Status buttons
(red bar)
These show the timecode
values for the start point,
only one of FM1 and FM2 is selected, the front file on
the thumbnail is output.
To recall in direct recall mode
Playback start point
(pale blue bar)
current position, and end
point.
Playback end point
(yellow bar)
Direct recall means that pressing a thumbnail immediately
recalls the file.
In this mode, only the front thumbnail file is recalled.
2 When [Pair] is Off, press a target FM selection button
to select the target.
To Next Page
Loading...
