Names and Functions of Parts of the Control Panel
• After recalling a register, press this button to
return to the state before recalling the
register.
• When contents have been saved to a
register, hold down the [STORE STATS]
button and press this button to return the
register to its state before the save
operation.
STORE
STATS
(store
status)
• When a save or delete operation has been
carried out on a register, this button lights
amber.
• After saving to a register, hold down this
button and press the relevant register button
to delete the data in the register.
• Again, after a save operation on a register,
hold down this button and press the [UNDO]
button to restore the register to its state
before the save operation.
Chapter
2
Menus
and
Control
Panel
e
XPT HOLD (cross-point hold) status display
A bus for which cross-point hold is set appears as a green
light.
f
Numeric display
Depending on the operation mode, this shows the pattern
number of a wipe or DME wipe, a bank number, a register
number, a transition rate, and so on in up to four digits.
Key Control Block
Each of the M/E banks and the PGM/PST bank includes
eight keyers (for keys 1 to 8), and you can delegate this
control block to any desired keyer. In this control block,
you can adjust and modify keys.
qg RESIZER button
9
DME channel
selection buttons
q;
ON AIR indicators
8
Displays
1
Delegation buttons
2
Key type selection
buttons
3
Key fill/key source
selection buttons
7
Knobs
4
Key modifier buttons
6
SHOW KEY button
5
MORE button
qf
AUTO DELEG button
qa Output destination specification buttons
qd TRACE button
qs OVERRIDE button
a
Delegation buttons
Pressing the following buttons selects a keyer and an M/E
or PGM/PST bank to which the key control block is
delegated.
To Next Page
Loading...
