Sony MVS-8000X SystemMVS-7000X System - Page 41

USO RESTRITO
Names and Functions of Parts of the Control Panel 41
Name
Description
EFF (effect)
To recall the master timeline or run an effect,
use this in combination with the buttons in the
memory recall section.
SHOTBOX
To recall or execute a shotbox, use this in
combination with the buttons of the memory
recall section.
MCRO
(macro)
To save, recall or edit a macro, use this in
combination with the buttons of the memory
recall section.
TRANS
RATE
(transition
rate)
• To enter the transition rate, press this
button, turning it on.
• To enter the independent key transition
rate, hold down this button, and press the
key delegation button in the independent
key transition control block.
• To select whether the value is entered in
frames or as a timecode value, switch the
[TC] button in the memory recall section on
or off.
Name
Description
BANK0
(bank 0)
Assigns the memory recall section to bank 0,
of registers 1 to 10.
BANK1
(bank 1)
Assigns the memory recall section to bank 1,
of registers 11 to 20.
BANK SEL
(bank
selection)
After pressing this button, press a button in
the memory recall section to select banks 0 to
9.
Name
Description
WIPE
To save or recall a wipe snapshot, or recall
the pattern number of a wipe pattern, use this
in combination with the buttons of the
memory recall section.
DME
To save or recall a DME wipe snapshot, or
recall the pattern number of a DME wipe
pattern, use this in combination with the
buttons of the memory recall section.
SNAPSHOT
To save or recall a snapshot, use this in
combination with the buttons of the memory
recall section.
Chapter
2
Menus
and
Control
Panel
1 Mode selection buttons
5 XPT HOLD status display
6 Numeric display
4 UNDO
button
3 Memory recall
section
2 Bank
selection
buttons
b Bank selection buttons
The following buttons are used to select a bank, and assign
the memory recall section to the registers of the selected
bank.
a Mode selection buttons
Pressing the following buttons selects the operation mode.
EFF
DISS
AUTO
TRAN
c Memory recall section
This consists of 12 buttons with LCDs. These display
changes, according to various operation modes.
d UNDO button
The following buttons are used to return a register to its
state before the register recall operation.