Sony MVS-8000X SystemMVS-7000X System - Selecting Cross-Point Assign Tables; Exporting Source Names and Destination Names; Making Settings for Audio Mixer

USO RESTRITO
584
Cross-Point Settings (Xpt Assign Menu)
Knob
Parameter
Adjustment
Setting values
1
Left No
Selection of copy
source
1 to 15
2
Right No
Selection of copy
destination
1 to 14
Knob
Parameter
Adjustment
Setting values
1
Station ID
Station ID setting
1 to 255
a)
Knob
Parameter
Adjustment
Setting values
1
Bank/Bus
No
Switcher bank or
bus selection
1 to maximum
value
2
Num
Number of
selected
switcher banks
or buses
1 to maximum
value
Chapter
19
Control
Panel
Setup
(Panel)
• Press directly on the list of copy sources (left-side
list) or the list of copy destinations (right-side list) in
the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
3 Press [Copy].
A confirmation message appears, asking whether or
not to execute the copy.
4 To execute the copy, press [Yes], and to cancel the
operation, press [No].
Knob
Parameter
Adjustment
Values
3
Table No
Selection of table
to be assigned
1 to 15
3 Press [Table Assign Set].
This sets the table for the selected switcher bank or
bus.
Exporting Source Names and
Destination Names
To send the source names and destination names to the S-
Bus, use the following procedure.
1 In the Panel >Xpt Assign menu, press [Name Export].
The Name Export menu appears.
2 Turn the knob to set the station ID.
Selecting Cross-Point Assign Tables
You can select the cross-point assign table to be used for
each of the following banks or buses.
• M/E-1 to M/E-5 banks and PGM/PST bank
• Buses assignable to AUX delegation buttons
Notes
It is not possible to assign cross-point tables 5 to 14 to a bus
of a switcher operated by an MKS-8080/8082 AUX Bus
Remote Panel.
1 In the Panel >Xpt Assign menu, using any of the
following methods, select the switcher bank or bus.
• Press directly on the list on the left of the status area.
• Press the arrow keys on the list on the left to scroll
the reverse video cursor.
• Turn the knobs.
a) If set to 255, the information is sent to all stations (with display of
“All”).
3 Press [Src Name Export].
This exports the source names to the station selected in
step 2.
4 Press [Dest Name Export].
This exports the destination names to the station
selected in step 2.
Notes
Since destination names cannot be selected freely,
fixed names are used.
Making Settings for Audio Mixer
2 Using any of the following methods, select the table.
• Press directly on the list on the right of the status
area.
• Press the arrow keys on the list on the right to scroll
the reverse video cursor.
• Turn the knob.
Enabling the function to link the audio
mixer
Notes
For audio mixer operations in this system, it is necessary
to set Mixer ESAM-II for the DCU 9-pin serial port.
For details, see “Serial Port Settings (Serial Port Assign
Menu)” (page 645).