Sony MVS-8000X SystemMVS-7000X System - Differences between Multi Program 2 Mode and Standard Mode; Restrictions on Using Multi Program 2 Mode

USO RESTRITO
Multi Program 2 259
Chapter
10
Special
Functions
Differences between Multi Program 2 Mode and Standard Mode
The differences from operation in standard mode are as
follows.
Item
Main
Sub
Keys
a)
Keys 1 to 8 can be used
Keys 2 to 8 only can be used
Wipes
(background)
Patterns
Same as standard mode
• Only standard patterns can be used
• Pattern mix is not possible
Modifiers
Same as standard mode
• Pairing, modulation, spring, spiral,
and split cannot be used
• Edge fill mattes are single-color
only
• Replication can be selected from
four patterns
Wipes (key)
Same as wipes (background) for sub
DME wipes
Use
Can be used
Cannot be used (Can be used, with a
setting change)
Patterns for 1 channel
For a dedicated interface, each of main and sub can be used.
For the SDI interface, only one of main and sub can be used.
Patterns for 2 channels
Only one of main and sub can be used.
For each M/E, the number of DMEs that can be used is the same as in
standard mode.
Patterns for 3 channels
Backgrounds
Wipe edge fill matte (including color
mix and other settings in the Matte
Adjust menu)
Wipe edge fill matte (single-color
only)
Modifiers
Same as standard mode
Wipe border colors are single-color
only
Transitions
Key priority
Cannot be used
Transition preview
Cannot be used
Preset color mix
Color matte or video signal selected
on the utility 2 bus
Color matte only
Snapshots
Cross-point hold
Utility 2 cannot be set
Utility 3 is added. BKGD A/B and
Key1 cannot be set.
Control from an editor
Same as standard mode
Cannot be used
Operation setting for switcher GPI inputs and
outputs
Same as standard mode
Cannot be used
a) Keys 2 to 8 are common to main and sub.
Notes
• Allow a transition to complete before carrying out main
and sub delegation switching.
• The sub background A bus (utility 2 bus) is shared with
wipe edge border fill. Making a change to one affects the
other.
• Even if the wipe border width is set to the same numeric
value for main and sub, the same image is not obtained.
Restrictions on Using Multi Program
2 Mode
• The following functions are not available for sub:
- Data copy and swap
- Default recall (except for parametric recall)
- [AUTO] button function (see page 68)
• Reentry is limited to four levels. Reentry is not possible
for main and sub of the same M/E.
However, this restriction can be removed.
For details, see “Enabling reentry between the main and
sub sides of the same M/E bank” (page 258).
• In the following cases, a transition using the fader lever
may not be performed correctly:
- When the main and sub bus toggle modes are set
differently
- For a pattern mix, preset color mix, and so on
• For an Internal bus link, GPI link, or External bus link,
the “Utility 2” bus cannot be selected.
• Screen aspect, show key, and [MCRO ATTCH ENBL]
button settings are common to main and sub.