Key Snapshots
Key settings other than the key on/off status and the key
priority can all be instantaneously saved in a dedicated
register, for recall when required. A key snapshot
comprises three values: a cross-point button number, key
memory full mode, and independent key transition, and
can be called in any combination.
There are four key snapshot registers for each keyer.
Key Snapshot Operations
Key snapshot operations are carried out in the independent
key transition control block, downstream key control
block or Multifunction Flexi Pad control block. Each keyer
is provided with four dedicated key snapshot registers.
The system switches to key snapshot mode, and the
key source name display/key snapshot buttons show
the status of registers 1 to 4 for key 1.
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
For a register holding a snapshot, the register name is
shown as up to eight characters.
3 Hold down the [K-SS STORE] button, and press the
key source name display/key snapshot button
corresponding to the register in which you want to
save the snapshot.
The key source name display/key snapshot button
which you pressed lights yellow.
Notes
If you save a key snapshot in a register for which the
button is lit orange or yellow, the existing contents of
the register are overwritten.
Key delegation buttons
Key source name display/
key snapshot buttons
Key snapshot setting
buttons
Recalling a key snapshot
For example, the following procedure recalls the state of
the M/E-1 key 1 settings.
1
In the M/E-1 independent key transition control block,
press the key delegation button [KEY1], turning it on.
2
Press the [K-SS] button, turning it on.
3
Set the following buttons on or off, depending on the
information you want to recall.
These buttons are not provided in the downstream key
control block.
[K-MOD ENBL] button: When this is on, the key
settings and key modifiers are recalled. When this
is off, they are not recalled.
Independent key transition control block (standard type)
Notes
To select [Key5] to [Key8] or [DSK5] to [DSK8] in the
independent key transition control block or downstream
key control block, a previous assignment in the Setup
menu is required (see page 397).
Saving a key snapshot
For example, the following procedure saves the state of the
M/E-1 key 1 settings.
1
In the M/E-1 independent key transition control block,
press the key delegation button [KEY1], turning it on.
2
Press the [K-SS] button, turning it on.
[K-TR ENBL] button: When this is on, the
independent key transition settings are recalled.
When this is off, they are not recalled.
If both buttons are off, the key memory function is
enabled and only the saved selection of key fill and key
source signals is recalled.
4
Press the key source name display/key snapshot button
corresponding to the register you want to recall.
The button you pressed lights yellow, and this recalls
the key snapshot.
To cancel a recall carried out in the downstream key
control block, press the [UNDO] button in the
downstream key control block.
To Next Page
Loading...
