Installation and Device Setup (Install/Unit Config Menu)
Switcher Upgrade Software
Texture Lighting Software
Chapter
18
System
Setup
(System)
Upper list: For each connected device, this shows the
device name, current software version (Current),
and the latest version that can be installed (Install,
Title).
-
OK: Installation already completed.
-
On: For installation, but not completed.
-
Error: An error occurred during installation.
-
Cancel: Installation canceled.
Lower list: For the device selected in the upper list,
this shows an automatically detected list of
software that can be installed on the particular
device. Also, software selected as a candidate for
installation in the upper list is marked in the lower
list with an bullet.
3
If you are satisfied with the currently installed version
of all items in the upper list, skip to step 6.
To change the items to be installed, use any of the
following methods to select the relevant device.
•
Press directly on the list in the status area.
•
Use the arrow keys to scroll the reverse video cursor.
•
Turn the knob.
The display of the lower list changes according to the
selected device.
Notes
When the MKS-7470X/7471X is selected, no software
is displayed in the lower list.
To display all related software
Press [Display All Software], turning it on.
The names of all related software for the selected
device appear, not just the automatically detected
software.
4
In the lower list, select the software you want to install.
•
Press directly on the list in the status area.
•
Use the arrow keys to scroll the reverse video cursor.
•
Turn the knob.
5
Press [Set].
The selection is reflected under “Install” and “Title” in
the upper list.
6
Press [Install].
The “Install” box shows “On,” confirming that this is
to be installed. To cancel this installation setting, press
“Install” once more, making the box blank.
7
Repeat steps 3 to 6, to confirm all software to be
installed.
8
Press [Execute].
A confirmation message appears.
9
Press [Yes].
This carries out the installation, and when it completes
normally, the “Install” box shows “OK.”
Making Settings Required to Use the
Software
To use the software listed below, you are required to enter
an install key which validates the software (if the software
has been factory installed, the install key is not required).
For the method of obtaining an install key, contact your
Sony representative. To obtain a key, you may be required
to submit the unique device ID of the switcher you are
using. You can check the unique device ID in the Install/
Unit Config menu of the switcher, using the following
procedure.
When using the MVS-8000X
Texture Lighting Software (for MVE-9000)
Switcher Upgrade Software
a) This can be used only on MVE-8000A.
When using the MVS-7000X
To Next Page
Loading...
