Key Adjustments (Multifunction Flexi Pad Control Block)
Pressing the [PAGE 1/4] > [PAGE 2/4] > [PAGE 3/4]
buttons further changes the display as follows, then
pressing [PAGE 4/4] returns to the original display
shown in the illustration.
[PAGE 4/4]
[PAGE 1/4]
With these buttons in the memory recall section, you can
carry out the following key adjustment.
[PAGE 2/4]
[PAGE 3/4]
Selecting the key type
[LUM] button: Selects a luminance key.
[LIN] button: Selects a linear key.
[CRK] button: Selects a chroma key.
[WIPE PTN] button: Selects a key wipe pattern key.
Adjust the parameters for each type with the adjustment
knobs. For details of the parameters, see the following
sections.
Luminance key: “When the [LUM] or [LIN] button is lit
green” (page 143)
Linear key: “When the [LUM] or [LIN] button is lit
green” (page 143)
Chroma key: “When the [CRK] button is lit green” (page
143)
Key wipe pattern key: “When the [PTN] button is lit
green” (page 143)
Selecting the key source
[AUTO SEL] button: The signal assigned as a pair with
the key fill bus signal for the key row button in the
cross-point control block is automatically selected.
[SPLT] button: Select a different signal manually. To
make the selection, hold down this button, and press
the button assigned to the signal you want as key
source in the cross-point control block.
You can also use the same signal as the key fill selected on
the key fill bus as key source (SELF). Press the [AUTO
SEL] button and [SPLT] button simultaneously so that
both are off, to select the SELF mode.
Setting auto chroma key
[SMPL MARK] button: Toggles the sample mark
display on and off. When on, the monitor screen shows
the foreground video and a white box sample mark.
To Next Page
Loading...
