AUX mix transition on/off
a) For details of pause events, see “Macro Execution” (page 498).
Symbols and Parameters
n: indicates a numeral 0 to 9. x: indicates an alphanumeric character.
Control blocks on the applicable bank
A, B, Key1 to Key8,
Key1Source to
Key8Source, Utility1,
Utility2, DMEExternalVideo
Main table cross-point button number
set in the Xpt Assign menu
Signal type selected on the applicable
bus (video signal or key signal)
EditPreview, AUX1 to
AUX48, FrameMemory1,
FrameMemory2,
DME1Video to
DME8Video, DME1Key to
DME8Key, DME1Video2nd
to DME8Video2nd (a),
DME1Key2nd to
DME8Key2nd (b),
DMEUtility1, DMEUtility2,
CCR1, CCR2
Applicable AUX bus
(a): DMEnVideo2nd= Bus for selecting
back video signal of DMEn channel
(n=1 to 8),
(b): DMEnKey2nd= Bus for selecting
back key signal of DMEn channel (n=1
to 8)
Cross-point button number in the main
table set in the Xpt Assign menu
Type of signal (video signal or key
signal) to be selected on the applicable
bus
Control blocks on the applicable bank
Transition rate (number of frames)
(a): Mode in which the current value set
on the transition control block is used
A bus or B bus cross-point button
number. Use the button number of the
main table set in the Xpt Assign menu.
(a): Mode in which the cross-point
number set for the current A bus or B
bus is used
Control blocks on the applicable bank
To Next Page
Loading...
