Wipe Pattern Operations in the Multifunction Flexi Pad Control Block
Saving, Canceling, and Deleting
Edited Wipe Patterns
Saving the edited wipe pattern as a
snapshot
Holding down the [WIPE] button, press the button in the
memory recall section for the register in which you want to
save.
The button you pressed lights yellow.
Buttons for registers in which wipe snapshots are already
saved light orange.
Canceling a saved wipe snapshot
Immediately after saving, hold down the [STOR STAT]
button and press the [UNDO] button.
Buttons for registers in which a wipe snapshot is saved are
lit orange.
Canceling recall of a wipe snapshot
To cancel the operation of recalling a wipe snapshot, press
the [UNDO] button.
Deleting the data of a saved wipe snapshot
Holding down the [DEL] button, press the button for the
register in which the wipe snapshot you want to delete is
saved.
The register button you pressed goes off.
To Next Page
Loading...
