Operation Settings (Operation Menu) 603
Select function to
be assigned to
button
Chapter
19
Control
Panel
Setup
(Panel)
Key Deleg/AUX: Use the key 1 row as a key and AUX
delegation button row, and the key 2 row as a
delegation cross-point button row.
Setting key 1 row delegation
1
In the Key Row Operation menu, press [Key Deleg/
AUX Assign].
The Key Deleg/AUX Assign menu appears.
2
Select the button you want to assign from the list on
the right.
3
Using any of the following methods, select the key to
be assigned from the list on the right.
•
Press directly on the list.
[Recall&Rewind] (the first keyframe is recalled)
in the <Recall Mode> group.
Automatically turning [EDIT ENBL] off: When an
effect is recalled with the [EDIT ENBL] button on,
to automatically turn this button off, disabling
keyframe editing, turn [Edit Enable Auto Off] on.
Automatic first keyframe insertion: When an empty
register is recalled, to automatically insert a first
keyframe of the state at that point, turn [1st KF
Auto Insert] on.
Automatic effect saving: To automatically save an
effected when it is recalled after being edited, turn
[Effect Auto Save] on.
Keyframe duration default value: Press [Default KF
Duration], then enter the default value from the
numeric keypad window.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
Setting the First Keyframe When a
Rewind is Executed
For P-Bus, GPI, and DDR/VTR timeline operations, to
execute the first keyframe when a rewind is carried out, set
each external device on in the <REWIND&1st KF> group
in the Effect Mode menu.
Setting the Transition Rate Display
Mode
To determine whether to display transition rate values in
menus and on the control panel in frames or as timecode
values, select either of the following in the <Trans Rate
Display> group.
Frame: display in frames.
Timecode: display as timecode (SS:FF).
Notes
When an effect is executed by pressing the [RUN] button
with this setting on, the first keyframe action is not
executed.
GPI: setting for the GPI timeline
P-Bus: setting for the P-Bus timeline
DDR/VTR: setting for the VTR/disk recorder/Extended
VTR timeline
Macro: setting for the macro timeline
Setting the Source and Destination
Making Settings Relating to Effects
To make settings relating to the functions used when
carrying out keyframe effect operations, use the following
procedure.
1
In the Panel >Operation menu, press [Effect Mode].
The Effect Mode menu appears.
The status area shows a list of the items with their
settings.
2
Make the following settings as required.
Effect recall mode: To select the state of the first
keyframe when an effect is recalled, select
[Recall] (the first keyframe is not recalled) or
Names
To set the Source and Destination names used in the
control panel, use the following procedure.
Notes
Before carrying out these settings, it is necessary to set the
number of the S-Bus description name (see page 653).
1 In the <Source/Dest Name> group of the Panel
>Operation menu, select the names to be used from the
following.
Sw’er Local: Source names set in the Xpt Assign
menu, and fixed bus names
S-B
us Descript: Description names set in the router
To Next Page
Loading...
