Sony MVS-8000X SystemMVS-7000X System - Applying Special Effects (Effects on the Overall Video Signal); Defocus Settings

USO RESTRITO
Applying Special Effects (Effects on the Overall Video Signal) 303
Chapter
11
DME
Operations
2 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Modifying the color combination pattern
See the following pages.
• “Setting the aspect ratio of the wipe crop pattern
(Aspect)” (page 301)
• “Replicating the wipe crop pattern (Multiplication)”
(page 301)
• “Rotating the wipe crop pattern (Rotation)” (page 301)
• “Applying modulation to the wipe crop pattern
(Modulation)” (page 301)
Applying Special Effects
(Effects on the Overall
Video Signal)
Defocus Settings
Applying the Defocus effect
1 In the DME menu, select VF2 ‘Video Modify’ and
HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2 Press [Defocus], turning it on.
Notes
On the MVE-8000A, the Defocus and Glow effects
cannot be enabled at the same time. The effect which
was turned on most recently is enabled.
3 In the <Defocus Mode> group, select the signal to
which to apply the defocus effect.
Video/Key: Video signal and key signal
Video: Video signal only
Key: Key signal only
Notes
“Key” can be selected only when the DME is
connected through an SDI interface.
4 Set the parameters.
When Video/Key is selected (with DME dedicated
interface)
Knob
Parameter
Adjustment
Setting values
1
H
Horizontal
defocusing of
video and
key signals
0.00 to 100.00
2
V
Vertical
defocusing of
video and
key signals
0.00 to 100.00
3
All
Horizontal
and vertical
defocusing of
video and
key signals
H value shown