Sony MVS-8000X SystemMVS-7000X System - Clip Output; Recording and Playback of Ancillary Data

USO RESTRITO
218
Frame Memory Clip Operations
Knob
Parameter
Adjustment
Setting values
1
No
Folder selection
1 to 12
2
Num
Number of files to
select
consecutively
from selected file
1 to 12
Knob
Parameter
Adjustment
Setting values
1
No
Folder selection
1 to 12
2
Num
Number of files to
select
consecutively
from selected file
1 to 12
Chapter
7
Frame
Memory
The Folder menu appears. The status area shows a list
of the current folder settings.
2 Select [New].
A keyboard window appears.
3 Enter the folder name, and press [Enter].
Changing the folder name
1 In the Frame Memory >Folder menu, select the folder
with the arrow keys or by turning the knobs.
2 Press [Rename].
A keyboard window appears.
3 Enter the new folder name, and press [Enter].
Notes
The following names cannot be used:
Default, Flash1, Flash2
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1,
COM2, COM3, COM4, COM5, COM6, COM7,
COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
Deleting a folder
1 In the Frame Memory >Folder menu, select the folder
with the arrow keys or by turning the knobs.
To select all folders, select [All].
2 Press [Delete].
A confirmation message appears.
3 To carry out the deletion select [Yes], and to cancel the
deletion select [No].
Notes
It is not possible to delete the default folder (named
“Default”).
Clip Output
As for still image operation, you can use the reposition and
lock functions.
For details of the operation, see “Image Output” (page
210).
Recording and Playback of Ancillary
Data
Preparations
To record ancillary data, it is first necessary in the Setup
menu to select “save with ancillary data” as the frame
memory saving mode.
For details, see “Saving a Frame Memory Clip With
Ancillary Data” in Chapter 18 (Volume 2).
Recording ancillary data
To record ancillary data in a frame memory clip, use the
Frame Memory >Clip >Record menu.
For details of the operating sequence, see “Clip Creation”
(page 217).
To check ancillary data during recording
If the ancillary data to be recorded is embedded audio, by
first setting the signal output to through mode, you can
listen while recording.
For the method of setting the signal output to through
mode, see “Signal Output Settings (Output Menu)” in
Chapter 20 (Volume 2).
Notes
For [Freeze Enable] or [Record Enable], in the <Record
Enable> group, pressing [Clip] or [Ext Clip] to turn them
on or off may result in noise. Also, with these buttons in
the On state, selecting the signal on the frame memory
source bus may result in noise.
Playing back ancillary data
You can play ancillary data recorded in a frame memory
clip by normal playback or an auto transition of the clip
transition.