Sony MVS-8000X SystemMVS-7000X System - Downstream Key;Fade-To-Black Control Block

USO RESTRITO
Names and Functions of Parts of the Control Panel 67
Name
Description
DSK1
(downstrea
m key 1)
ON to DSK4
ON buttons
• Press these to instantaneously cut the
downstream keys 1, 2, 3, and 4 in.
• When a key is already inserted, pressing
the button cuts it out.
• When the key corresponding to the button
appears in the final program output, the
button lights red, and otherwise lights
amber.
TAKE
buttons
• These correspond to downstream keys 1, 2,
3, and 4 from left to right; press to execute
an auto transition. The transition starts
immediately, and the button lights amber.
• When the transition completes, the button
goes off.
Fader lever
Move this vertically to carry out a manual
downstream key transition.
Transition
indicator
This comprises multiple LEDs, which show
the progress of the downstream key transition.
Name
Description
K-SS (key
snapshot)
This enables key snapshot mode.
K-SS
STORE
(key
snapshot
store)
To save a key snapshot, hold down this
button, and press the key source name
display/key snapshot button for the register
you want to save.
UNDO (key
snapshot
recall undo)
This undoes the last key snapshot recall.
Chapter
2
Menus
and
Control
Panel
Downstream Key/Fade-to-Black
Control Block
4 Key source name display/key snapshot buttons
3 K-SS button
5 FTB button
d Key snapshot setting buttons
Pressing the following buttons carries out key snapshot
operations.
7 Preview selection
buttons
6 AUTO button
2 Independent key transition
execution section
1 Key delegation
buttons
e Key source name display/key snapshot buttons
These display the selected source name for each
corresponding keyer. In snapshot mode, they correspond
to registers 1 to 4 of the selected keyer, and pressing the
button saves or recalls a key snapshot.
a Key delegation buttons
Press the [DSK1] or [DSK2] button to select the keyer.
Each button can be assigned to any key in setup.
For details, see “Assigning Keys to the DSK1 and DSK2
Buttons in the Downstream Key/Fade-to-Black Control
Block” in Chapter 19 (Volume 2).
While these buttons are held down, you can select a key
source with the cross-point buttons on the key bus.
Pressing one of these buttons twice in rapid succession
changes its state so that you can make cross-point
selections on the corresponding key bus in the PGM/PST
bank.
b Independent key transition execution section
Pressing the following buttons carries out transition
operations of the corresponding downstream key.