Snapshot Operations in the Flexi Pad Control Block
When a master snapshot is recalled, the region
selection buttons light according to the saved region
information.
To cancel a snapshot recall operation
To cancel the recall, press the [UNDO] button.
Notes
It is not possible to cancel recalling a master snapshot.
Creating and saving a master snapshot
with the numeric keypad control block
To create and save a master snapshot with the numeric
keypad control block, refer to the operations in “Creating
and Saving a Master Timeline Using the Buttons in the
Numeric Keypad Control Block” (page 464). Note,
however, that in place of the [EFF] button in the numeric
keypad control block, the [SNAPSHOT] button is used.
Snapshot Operations in
the Flexi Pad Control
Block
In the Flexi Pad control block (standard type or simple
type) on each M/E bank and PGM/PST banks, you can
only carry out operations on snapshots for that bank. It is
therefore not necessary to select a region.
UNDO button
Numeric display
STORE
STATS
SNAPSHOT
button
Memory recall
section
button
Bank
selection
buttons
Flexi Pad control block (standard type)
Numeric display
SNAPSHOT
button
UNDO button
Memory recall
section
Flexi Pad control block (simple type)
Banks and Registers
In a standard type Flexi Pad control block or Multifunction
Flexi Pad control block, in order to handle the 99 registers,
they are considered in groups. These groups are called
“banks,” and there are ten banks, numbered from 0 to 9.
The correspondence between banks and registers is shown
in the following table.
To Next Page
Loading...
