Chapter
3
Signal
Selection
and
Transitions
Notes
When executing an AUX mix translation bus, always
select an odd-numbered bus. Selecting an even-
Simple Transition
numbered bus will not execute a transition, even if
AUX mix transitions are enabled.
2
In the row of cross-point buttons, select the image for
before the transition.
3
Press the [AUX MIX] button, turning it on.
Basic Operations for Simple
Transitions
A simple-type transition control block is used to carry out
a transition.
Notes
If the bus assigned to the 2nd row cross-point buttons
is different from the bus assigned to the 1st row, press
the [2ND AUX MIX] button, and not [AUX MIX], to
execute an AUX mix transition on the 2nd row.
4
In the row of cross-point buttons, select the image for
after the transition.
This executes the transition at the preset transition rate.
The image during the transition is output from the
AUX1 bus. The image selected in step 4 is output from
the AUX2 bus.
Key transition selection buttons
Key status display
Transition type selection buttons
Transition execution section
Transition control block (simple right-hand type)
Notes
The simple transition control block cannot be installed in
the CCP-6224/6324 Control Panel.
Carrying out a transition using a simple-
type transition control block
1
With the background A row of cross-point buttons in
the cross-point control block, select the background
video.
2
Using one of the following methods, select the way in
which the transition will affect the image.
Use a combination of the transition type selection
buttons ([MIX], [NAM], [WIPE] and [DME]) and the
next transition selection buttons ([KEY1] and
[KEY2]).
For an overview of the mix, NAM, wipe, and DME
wipe transition types, see “Transition Types” (page
95).
To Next Page
Loading...
