Sony MVS-8000X SystemMVS-7000X System - Masks

USO RESTRITO
Key Adjustments (Menus) 137
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
4
Density
Density
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
1
Size
Pattern size
0.00 to 100.00
2
Soft
Pattern edge
softness
0.00 to 100.00
3
Density
Density
0.00 to 100.00
Chapter
4
Keys
When turning [Multi] on and replicating the
pattern
Knob
Parameter
Adjustment
Setting values
1
H Multi
Number of
repetitions of
pattern
horizontally
1 to 63
2
V Multi
Number of
repetitions of
pattern vertically
1 to 63
3
Invert Type
Replication
layout
1 to 4
a)
a) See page 171.
When turning [Aspect] on and setting the aspect
ratio of the pattern
Knob
Parameter
Adjustment
Setting values
1
Aspect
Aspect ratio
–100.00 to
+100.00
a)
a) See page 171.
When turning [Angle] on in the <Rotation> group
and inclining the pattern
Knob
Parameter
Adjustment
Setting values
1
Angle
Angle of pattern
rotation
–100.00 to
+100.00
a)
a) See page 170.
When turning [Speed] on in the <Rotation> group
and rotating the pattern at a constant speed
Knob
Parameter
Adjustment
Setting values
1
Speed
Rotation rate of
pattern
–100.00 to
+100.00
a)
a) See page 170.
6 To interchange color 1 and color 2, press [Color
Invert], turning it on.
Notes
If in the pattern selection described below you select
“Mask Pattern,” and “Box” for the main mask, the
“Size” parameter here cannot be adjusted. Set “Size”
in the Main Mask menu.
3 To adjust the pattern and color, press [Zabton Adjust].
The Zabton Adjust menu appears.
4 In the <Zabton Pattern> group, select the pattern.
Key Wipe: Use a key wipe.
You can change this pattern by pressing [Pattern
Select] to open the menu for key wipe pattern
selection (Pattern Select menu), and make
adjustments by pressing [Pattern Adjust] to open
the menu for pattern adjustment (Wipe Adjust menu).
Key Edge Pattern: Use a color mixing pattern for key edge.
You can change this pattern by pressing [Pattern
Select] to open the menu for edge color mix
dedicated wipe pattern selection (Mix Pattern
Select menu), and make adjustments by pressing
[Pattern Adjust] to open the menu for pattern
adjustment (Matte Adjust menu).
Mask Pattern: Use the main mask Box or Pattern.
You can also press [Pattern Select], and in the
corresponding pattern adjustment menu, change the
pattern.
5 To adjust the color, press [Zabton Color] and adjust
the following parameters.
Applying the zabton effects
1 In the Edge menu, press [Zabton], turning it on.
2 Adjust the following parameters.
Masks
There are two masks, which can be used to mask off
unneeded parts of a key or background, or to remove
defects, and these are known as the main mask and
subsidiary mask.
You can either use the main mask and subsidiary mask
independently, or at the same time.
Using the main mask
For example, to use the main mask for key 1 on the M/E-1
bank, use the following procedure.