Sony MVS-8000X SystemMVS-7000X System - Copy and Swap Operations

USO RESTRITO
Copy and Swap 231
Target
bank
Target keyer and data
DME ch1 to
ch8
• Background
• Border
• Sepia
• Light
• Shade
• Drop shadow (other than DME ch4 and
DME ch8)
• Trail
Target
bank
Target keyer and data
M/E-1 M/E-
2 M/E-3
M/E-4 M/E-
5
PGM/PST
• Keys 1 to 8
• Downstream keys
1 to 8
• Matte data for key fill
• Matte data for key
edge fill
Matte data for wipe border edge
Color
background
• Matte data for color background 1
• Matte data for color background 2
Target
bank
Target keyer and data
M/E-1 M/E-
2 M/E-3
M/E-4 M/E-
5
PGM/PST
• Keys 1 to 8
• Downstream keys
1 to 8
• Colors 1 and 2 for
key fill
• Colors 1 and 2 for
key edge fill
• “Zabton” color data
Colors 1 and 2 for wipe border
Color data for preset color mix
Color
background
• Colors 1 and 2 for color background 1
• Colors 1 and 2 for color background 2
Frame
memory
• FM1 color
• FM2 color
Chapter
8
Color
Backgrounds,
Copy
and
Swap,
and
Other
Settings
Target
bank
Target data
M/E-1
DME wipe settings.
M/E-2
It is not, however, possible to carry out copy or
M/E-3
swap involving independent key transition DME
M/E-4
wipe settings.
M/E-5
PGM/
PST
DME wipe copy and DME wipe swap in the
independent key transition control block
You can copy and swap the DME wipe settings among the
keyers listed in the following table.
Target
bank
Target keyer
Target data
M/E-1
Keys 1 to 8
DME wipe settings in the
M/E-2
But excluding keys 5 to 8
independent key
M/E-3
on M/E-4 In the MVS-
transition control block.
M/E-4
8000X
M/E-5
PGM/
PST
Downstream keys 1 to 8
Matte data copy and swap
You can copy or swap the matte data among the color
generators listed in the following table.
DME channel copy and swap
You can copy and swap the channel data among DME
channels 1 to 4 or DME channels 5 to 8.
It is not possible to copy or swap the channel data between
DME channels 1 to 4 and DME channels 5 to 8.
Notes
On the MVS-8000X, when the signal format is 1080P, the
combinations for a copy or swap are restricted as follows.
• Channels 1 and 2
• Channels 3 and 4
• Channels 5 and 6
• Channels 7 and 8
On the MVS-7000X, when the signal format is 1080P, the
above restriction also applies if using the MVE-8000A.
There is no such restriction for the MKS-7470X/7471X.
Copying format converter data
You can copy data from one format converter input to
another or from one output to another.
Notes
The copy source and destination data must be in the same
signal format.
Color data copy and swap
You can copy or swap the color data among the color
generators listed in the following table.
Copy and Swap Operations
Copy and Swap menu operations
In the menu operation section top menu selection buttons,
press [COPY SWAP], then press VF1 ‘Copy/Swap’ or
VF2 ‘Copy.’ The Copy/Swap menu appears.
Here a copy/swap operation on wipe data is described by
way of example, using the Copy/Swap >Wipe menu, but
the same general procedure applies to all of the following
menus.
• M/E: Copying and swapping M/E data
• Key: Copying and swapping key data
• Wipe: Copying and swapping wipe data
• DME Wipe: Copying and swapping DME wipe data
• Matte: Copying and swapping matte data
• Color: Copying and swapping color data