Sony MVS-8000X SystemMVS-7000X System - Keyframe Strobe Settings

USO RESTRITO
334
Applying Special Effects (Lighting and Recursive Effects)
Chapter
11
DME
Operations
Keyframe Strobe Settings
Notes
When you turn on keyframe strobe, if the Trail, Motion
Decay or Wind effect is on, it automatically goes off.
Leaving a trail of afterimages of the image
1 In the DME menu, select VF5 ‘Light/Trail’ and HF4
‘KF Strobe.’
The KF Strobe menu appears.
2 Press [KF Strobe], turning it on.
3 Set the following parameter.
Knob
Parameter
Adjustment
Setting values
1
Decay
Degree of
blurring of the
video signal
0.00 to 100.00
a)
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the
afterimage does not decay.
4 To erase the afterimage, press [KF Strobe Eraser],
turning it on.
Selecting the overlay priority for movie and
still images (video freeze image)
In the <Priority> group, select the way in which the images
are overlaid.
Over: the movie is on top, and the still image is
underneath.
Under: the movie is underneath, and the still image is on
top.
Mix: the movie and still images are mixed; adjust the
following parameter with the knob.
Knob
Parameter
Adjustment
Setting values
1
Mix
Mix amount of
the still image
with respect to
the movie
0.00 to 100.00
a)
a) The 0.00 setting is the same as Over, and the 100.00 is the same as
Under.
Selecting the freeze timing
In the <KF Freeze Timing> group, select the timing for
freezing the keyframe strobe.
Frame: freeze in frame units.
Field: freeze in field units.
Notes
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.976,
1080PsF/24, 1080PsF/25, 1080PsF/29.97, 720P/
50, 720P/59.94
Erasing the afterimages that remain in
memory whenever a keyframe is passed
Press [KF Strobe Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Applying stardust to the afterimage
portion
The afterimage portion becomes stardust, and gradually
disappears.
1 Press [Dust], turning it on.
2 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
KF Strobe
Dust
Amount of the
afterimage
disappearing as
stardust
a)
0.00 to 100.00
2
Dust Soft
Timing with
which stardust
disappears
0.00 to 100.00
3
Dust Size
Size of stardust
0.00 to 100.00
4
Dust
Aspect
Aspect ratio of
stardust
–100.00 to
+100.00
a) The way in which the afterimage disappears is affected by both the
Decay and KF Strobe Dust parameter adjustments for the keyframe
strobe.
Disabling the keyframe strobe afterimage
Press [KF Strobe Disable], turning it on.
If you turn this function on when creating a keyframe, even
as the effect passes a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or
after the combine.
Notes
• The combine process function is not supported on the
MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.